![]() ![]() Is 1mm deviation as close as it gets? Are my hopes too high for this unit? I’m not opposed to completely disassembling it and boring out the trunnion mounting holes if needed, but would prefer to avoid that if possible. The saw itself is in great condition, no play in the bearings. 5 in the original manual, see link below.) The tilt screw seems to be holding the front of the arbor in a way that prevents it from adjustment.ĭoes anyone here have experience with this saw? I’m hoping for some tips and or tricks. ![]() The most significant gain was made when I loosened the clamp screw and applied lateral force. I tried the manual’s method of loosening the trunnion bolts and shifting, but there doesn’t seem to be any play in the mounting holes. Even a non-functioning saw can go for 50-80, as many enthusiasts want vintage parts. I’m measuring a marked tooth at full extension but the closest I can get is a 1mm deviation. A Craftsman model 113 table saw in solid working condition can go for approximately 100-200 depending on the state it is in. I‘m trying to set the blade perfectly parallel to the miter slots, but can’t get the darn thing right. Hey guys, I’m seeking guidance on tuning a stubborn table saw. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |